Setting Device-ppi manualy?
Posted: Wed Dec 05, 2007 12:33 pm
Hello,
is it possible to set
ppixDevice and ppiyDevice in RV_InfoAboutSaD manually before formating?
Because i have some problems with tabs. I create my own PrintPreview with the specific resolution of the printer, but it is not the printer-canvas, where i painting. So - tabs are not correcly drawed on ppi <> 96.
if i set this properties manually, it works fine
Thanks, Sven
is it possible to set
ppixDevice and ppiyDevice in RV_InfoAboutSaD manually before formating?
Because i have some problems with tabs. I create my own PrintPreview with the specific resolution of the printer, but it is not the printer-canvas, where i painting. So - tabs are not correcly drawed on ppi <> 96.
if i set this properties manually, it works fine
Thanks, Sven